The DynaVap XL Titanium Condenser fits most 109 mm DynaVap devices and comes with all necessary o-rings, three in total.
The DynaVap XL Titanium Condenser is a spare part for DynaVap devices, made of titanium and supplied with its own o-rings. DynaVap states that it fits most 109 mm DynaVap devices and that its job is to give midsections of stem length, 62 mm, a spinning mouthpiece. Below you find the figures the maker gives, the models it names and the care notes from its support pages. Where the maker gives no figure, we leave the line out.
DynaVap lists the part for these midsections with a spinning mouthpiece: B, M, VonG, WoodWynd, UniDyn, Omni, Hyper and Bonger XL. In our range the WoodWynd Ipe and the UniDyn Titanium carry two of the listed names. Check that your midsection is stem length, 62 mm, before you choose this part.
The maker's anatomy guide shows the condenser inside the stem. Its o-rings sit on the condenser, and one ring is slightly larger: that one goes in the centre. The compatibility chart marks small, large and tip o-rings. The pack holds three o-rings, which DynaVap calls all the necessary ones. The maker does not state which sizes the three rings are, so we do not list them, and no weight is given either.
The rings are made of Viton rubber. DynaVap advises moisturising the o-rings regularly. It also warns not to soak the device in alcohol while the o-rings are on, so take them off before any cleaning of that kind.
All DynaVap parts are in the DynaVap category and on the DynaVap brand page. Complete devices are under dry herb vaporizer.
How many o-rings does the DynaVap XL Titanium Condenser come with? Three in total, which the maker calls all the necessary o-rings.
Which length of midsection does it suit? Stem length midsections of 62 mm, on most 109 mm DynaVap devices.